ncgsmwen 2006-5-5 07:55
3GPP TS 25.101_ _UE Radio transmission and Reception (FDD)
【资料成文时间】：
【语言】：英语
【页数】：70
【何人（公司）所著】：3GPP2
【文件格式】：WORD
【文件原名】：
【摘要或目录】：Foreword 7
1 Scope 8
2 References 8
3 Definitions, symbols and abbreviations 8
3.1 Definitions 8
3.2 Abbreviations 9
4 General 10
4.1 Relationship between Minimum Requirements and Test Requirements 10
4.2 Power Classes 10
4.3 Control and monitoring functions 10
4.3.1 Minimum requirement 11
5 Frequency bands and channel arrangement 11
5.1 General 11
5.2 Frequency bands 11
5.3 TX–RX frequency separation 11
5.4 Channel arrangement 11
5.4.1 Channel spacing 11
5.4.2 Channel raster 11
5.4.3 Channel number 12
5.4.4 UARFCN 12
6 Transmitter characteristics 12
6.1 General 12
6.2 Transmit power 13
6.2.1 UE maximum output power 13
6.3 Frequency Error 13
6.4 Output power dynamics 13
6.4.1 Open loop power control 13
6.4.1.1 Minimum requirement 13
6.4.2 Inner loop power control in the uplink 14
6.4.2.1 Power control steps 14
6.4.2.1.1 Minimum requirement 14
6.4.3 Minimum output power 14
6.4.3.1 Minimum requirement 15
6.4.4 Out-of-synchronization handling of output power 15
6.4.4.1 Minimum requirement 15
6.4.4.2 Test case 15
6.5 Transmit ON/OFF power 16
6.5.1 Transmit OFF power 16
6.5.1.1 Minimum requirement 16
6.5.2 Transmit ON/OFF Time mask 16
6.5.2.1 Minimum requirement 16
6.5.3 Change of TFC 18
6.5.3.1 Minimum requirement 18
6.5.4 Power setting in uplink compressed mode 19
6.5.4.1 Minimum requirement 19
6.6 Output RF spectrum emissions 20
6.6.1 Occupied bandwidth 20
6.6.2 Out of band emission 20
6.6.2.1 Spectrum emission mask 21
6.6.2.1.1 Minimum requirement 21
6.6.2.2 Adjacent Channel Leakage power Ratio (ACLR) 21
6.6.2.2.1 Minimum requirement 21
6.6.3 Spurious emissions 22
6.6.3.1 Minimum requirement 22
6.7 Transmit intermodulation 22
6.7.1 Minimum requirement 22
6.8 Transmit modulation 23
6.8.1 Transmit pulse shape filter 23
6.8.2 Error Vector Magnitude 23
6.8.2.1 Minimum requirement 23
6.8.3 Peak code domain error 23
6.8.3.1 Minimum requirement 23
7 Receiver characteristics 24
7.1 General 24
7.2 Diversity characteristics 24
7.3 Reference sensitivity level 24
7.3.1 Minimum requirement 24
7.4 Maximum input level 24
7.4.1 Minimum requirement 25
7.5 Adjacent Channel Selectivity (ACS) 25
7.5.1 Minimum requirement 25
7.6 Blocking characteristics 25
7.6.1 Minimum requirement 26
7.7 Spurious response 27
7.7.1 Minimum requirement 27
7.8 Intermodulation characteristics 27
7.8.1 Minimum requirement 27
7.9 Spurious emissions 28
7.9.1 Minimum requirement 28
8 Performance requirement 28
8.1 General 28
8.2 Demodulation in static propagation conditions 28
8.2.1 (void) 28
8.2.2 Demodulation of Forward Access Channel (FACH) 28
8.2.3 Demodulation of Dedicated Channel (DCH) 28
8.2.3.1 Minimum requirement 29
8.3 Demodulation of DCH in multi-path fading propagation conditions 29
8.3.1 Single Link Performance 29
8.3.1.1 Minimum requirement 29
8.4 Demodulation of DCH in moving propagation conditions 31
8.4.1 Single link performance 31
8.4.1.1 Minimum requirement 32
8.5 Demodulation of DCH in birth-death propagation conditions 32
8.5.1 Single link performance 32
8.5.1.1 Minimum requirement 32
8.6 Demodulation of DCH in downlink Transmit diversity modes 33
8.6.1 Demodulation of DCH in open-loop transmit diversity mode 33
8.6.1.1 Minimum requirement 33
8.6.2 Demodulation of DCH in closed loop transmit diversity mode 33
8.6.2.1 Minimum requirement 33
8.6.3 Demodulation of DCH in Site Selection Diversity Transmission Power Control mode 34
8.6.3.1 Minimum requirements 34
8.7 Demodulation in Handover conditions 35
8.7.1 Demodulation of DCH in Inter-Cell Soft Handover 35
8.7.1.1 Minimum requirement 35
8.7.2 Combining of TPC commands from radio links of different radio link sets 35
8.7.2.1 Minimum requirement 35
8.7.3 Combining of reliable TPC commands from radio links of different radio link sets 36
8.7.3.1 Minimum requirement 36
8.8 Power control in downlink 37
8.8.1 Power control in the downlink, constant BLER target 37
8.8.1.1 Minimum requirements 37
8.8.2 Power control in the downlink, initial convergence 38
8.8.2.1 Minimum requirements 38
8.8.3 Power control in downlink, wind up effects 38
8.8.3.1 Minimum requirements 38
8.9 Downlink compressed mode 39
8.9.1 Single link performance 39
8.9.1.1 Minimum requirements 39
8.10 Blind transport format detection 40
8.10.1 Minimum requirement 40
8.11 Detection of Broadcast channel (BCH) 41
8.11.1 Minimum requirement 41
8.12 Demodulation of Paging Channel (PCH) 41
8.12.1 Minimum requirement 42
8.13 Detection of Acquisition Indicator (AI) 42
8.13.1 Minimum requirement 42
Annex A (normative): Measurement channels 43
A.1 General 43
A.2 UL reference measurement channel 43
A.2.1 UL reference measurement channel (12.2 kbps) 43
A.2.2 UL reference measurement channel (64 kbps) 44
A.2.3 UL reference measurement channel (144 kbps) 45
A.2.4 UL reference measurement channel (384 kbps) 46
A.2.5 UL reference measurement channel (768 kbps) 47
A.3 DL reference measurement channel 48
A.3.1 DL reference measurement channel (12.2 kbps) 48
A.3.2 DL reference measurement channel (64 kbps) 49
A.3.3 DL reference measurement channel (144 kbps) 50
A.3.4 DL reference measurement channel (384 kbps) 50
A.4 DL reference measurement channel for BTFD performance requirements 52
A.5 DL reference compressed mode parameters 54
A.6 DL reference parameters for PCH tests 55
Annex B (normative): Propagation conditions 56
B.1 General 56
B.2 Propagation Conditions 56
B.2.1 Static propagation condition 56
B.2.2 Multi-path fading propagation conditions 56
B.2.3 Moving propagation conditions 56
B.2.4 Birth-Death propagation conditions 57
Annex C (normative): Downlink Physical Channels 58
C.1 General 58
C.2 Connection Set-up 58
C.3 During connection 58
C.3.1 Measurement of Rx Characteristics 58
C.3.2 Measurement of Performance requirements 59
C.3.3 Connection with open-loop transmit diversity mode 60
C.3.4 Connection with closed loop transmit diversity mode 60
C.4 W-CDMA Modulated Interferer 61
Annex D (normative): Environmental conditions 62
D.1 General 62
D.2 Environmental requirements 62
D.2.1 Temperature 62
D.2.2 Voltage 62
D.2.3 Vibration 62
Annex E (informative): UE capabilities (FDD) 64
Annex F (informative): Change history 65