ghost005 2007-10-14 19:41
ＧＳＭ标准
>>发附件贴请务必注明以下选项：>>
【资料成文时间】： 2005
【语言】：English
【页数】： 129
【何人（公司）所著】： 3rd Generation Partnership Project;
Technical Specification Group GSM/EDGE
Radio Access Network;
Radio transmission and reception
【文件格式】： doc
【文件原名】： 3GPP TS 45.005 V7.1.0
【摘要或目录】：Contents
Foreword 6
1 Scope 7
1.1 References 7
1.2 Abbreviations 8
2 Frequency bands and channel arrangement 9
3 Reference configuration 11
4 Transmitter characteristics 12
4.1 Output power 12
4.1.1 Mobile Station 12
4.1.2 Base station 16
4.1.2.1 Additional requirements for PCS 1 900 and MXM 1900 Base stations 17
4.1.2.2 Additional requirements for GSM 850 and MXM 850 Base stations 17
4.1.2.3 Additional requirements for GSM 700 Base stations 18
4.2 Output RF spectrum 18
4.2.1 Spectrum due to the modulation and wide band noise 18
4.2.2 Spectrum due to switching transients 22
4.3 Spurious emissions 24
4.3.1 Principle of the specification 24
4.3.2 Base Transceiver Station 25
4.3.2.1 General requirements 25
4.3.2.2 Additional requirements for co-existence with GSM systems on other frequency bands 26
4.3.2.3 Additional requirements for co-existence with 3 G 27
4.3.3 Mobile Station 27
4.3.3.1 Mobile Station GSM 400, T-GSM 810, GSM 900 and DCS 1 800 27
4.3.3.2 Mobile Station GSM 700, GSM 850 and PCS 1 900 28
4.4 Radio frequency tolerance 29
4.5 Output level dynamic operation 29
4.5.1 Base Transceiver Station 29
4.5.2 Mobile Station 29
4.6 Modulation accuracy 30
4.6.1 GMSK modulation 30
4.6.2 8-PSK modulation 30
4.6.2.1 RMS EVM 30
4.6.2.2 Origin Offset Suppression 31
4.6.2.3 Peak EVM 31
4.6.2.4 95:th percentile 31
4.7 Intermodulation attenuation 31
4.7.1 Base transceiver station 31
4.7.2 Intra BTS intermodulation attenuation 31
4.7.2.1 GSM 400, GSM 900, DCS 1800 31
4.7.2.2 MXM 850 and MXM 1900 32
4.7.2.3 GSM 700, GSM 850 and PCS 1900 32
4.7.3 Void 32
4.7.4 Mobile PBX (GSM 900 only) 32
5 Receiver characteristics 33
5.1 Blocking characteristics 33
5.2 AM suppression characteristics 37
5.3 Intermodulation characteristics 38
5.4 Spurious emissions 38
6 Transmitter/receiver performance 39
6.1 Nominal Error Rates (NER) 39
6.1.1 GMSK modulation 39
6.1.2 8-PSK modulation 40
6.2 Reference sensitivity level 40
6.3 Reference interference level 45
6.4 Erroneous frame indication performance 48
6.5 Random access and paging performance at high input levels 48
6.6 Frequency hopping performance under interference conditions 49
6.7 Incremental Redundancy Performance for EGPRS MS 49
Annex A (informative): Spectrum characteristics (spectrum due to the modulation) 85
Annex B (normative): Transmitted power level versus time 91
Annex C (normative): Propagation conditions 94
C.1 Simple wideband propagation model 94
C.2 Doppler spectrum types 94
C.3 Propagation models 95
C.3.1 Typical case for rural area (RAx): (6 tap setting) 95
C.3.2 Typical case for hilly terrain (HTx): (12 tap setting) 95
C.3.3 Typical case for urban area (TUx): (12 tap setting) 96
C.3.4 Profile for equalization test (EQx): (6 tap setting) 96
C.3.5 Typical case for very small cells (TIx): (2 tap setting) 96
Annex D (normative): Environmental conditions 97
D.1 General 97
D.2 Environmental requirements for the MSs 97
D.2.1 Temperature (GSM 400, GSM 900 and DCS 1 800) 97
D.2.1.1 Environmental Conditions (PCS 1 900, GSM 850 and GSM 700) 97
D.2.2 Voltage 97
D.2.3 Vibration (GSM 400, GSM 900 and DCS 1 800) 98
D.2.3.1 Vibration (PCS 1 900, GSM 850 and GSM 700) 98
D.3 Environmental requirements for the BSS equipment 98
D.3.1 Environmental requirements for the BSS equipment 99
Annex E (normative): Repeater characteristics 100
E.1 Introduction 100
E.2 Spurious emissions 100
E.3 Intermodulation products 101
E.4 Out of band gain 101
E.5 Frequency error and modulation accuracy 101
E.5.1 Frequency error 101
E.5.2 Modulation accuracy at GMSK modulation 101
E.5.3 Modulation accuracy at 8-PSK modulation 101
Annex F (normative): Antenna Feeder Loss Compensator Characteristics (GSM 400, GSM 900 and DCS 1800) 103
F.1 Introduction 103
F.2 Transmitting path 103
F.2.1 Maximum output power 103
F.2.2 Gain 104
F.2.3 Burst transmission characteristics 104
F.2.4 Phase error 104
F.2.5 Frequency error 105
F.2.6 Group delay 105
F.2.7 Spurious emissions 105
F.2.8 VSWR 106
F.2.9 Stability 106
F.3 Receiving path 106
F.3.1 Gain 106
F.3.2 Noise figure 106
F.3.3 Group delay 106
F.3.4 Intermodulation performance 106
F.3.5 VSWR 106
F.3.6 Stability 106
F.4 Guidelines (informative) 106
Annex G (normative): Calculation of Error Vector Magnitude 108
Annex H (normative): Requirements on Location Measurement Unit 110
H.1 TOA LMU Requirements 110
H.1.1 Void 110
H.1.2 LMU characteristics 110
H.1.2.1 Blocking characteristics 110
H.1.2.2 AM suppression characteristics 110
H.1.2.3 Intermodulation characteristics 111
H.1.2.4 Spurious emissions 111
H.1.3 Time-of-Arrival Measurement Performance 111
H.1.3.1 Sensitivity Performance 111
H.1.3.2 Interference Performance 112
H.1.3.3 Multipath Performance 113
H.1.4 Radio Interface Timing Measurement Performance 113
H.2 E-OTD LMU Requirements 113
H.2.1 LMU Characteristics 113
H.2.1.1 Blocking characteristics 114
H.2.1.2 AM suppression characteristics 114
H.2.1.3 Intermodulation characteristics 114
H.2.2 Sensitivity and Interference Performance 114
H.2.2.1 Sensitivity Performance 114
H.2.2.2 Interference Performance 115
H.2.2.3 Multipath Performance 115
Annex I (normative): E-OTD Mobile Station Requirements 117
I.1 Introduction 117
I.2 Sensitivity and Interference Performance 117
I.2.1 Sensitivity Performance 117
I.2.2 Interference Performance 118
I.2.3 Multipath Performance 118
Annex J (informative): Guidance on the Usage of Dynamic ARFCN Mapping 119
J.1 Introduction 119
J.2 Dynamic allocation of GSM 400, GSM 800, GSM 900, DCS 1800 and PCS 1900 ARFCNs 119
J.3 Controlling changes in dynamic mapping 119
Annex K (normative): Reference TFCs for FLO 121
Annex L (normative): Reference Test Scenarios for DARP 123
Annex M (informative): Change history 125